| Datasheet: |
 |
| BI Communications TX2003 Graphical TDR Cable Fault Locator Description: |
 BI Communications TX2003 Graphical TDR Cable Fault Locator, 6k (19.000ft) range time domain reflectometer weighing only 350 grams (13oz) fits neatly in to the hand.

With its 128 x 64 pixel backlight scratch resistant display, provides accurate and easy to read fault locations on metallic cables.with a 3 nano second pulse , rise time "near end" cable faults can be clearly identified without the need to supress the transmitted pulse . housed in a rugged IP54 rated ABS enclosure , the TX2003 is suitable for outside use.

Using pre determined gain and pulse widths for each range settinjg and with only 4 control buttons, all major operating and setting parameters can be easily accessed .A 6km cable run can be scanned in seconds , allowing the operator a view of the cable run , yet arriving quickly to the fault. By using the tx2003 scan lock facility . the cable can be continually scanned or the trace held for closer analysis. to enable the TX2003 to test all metalic cables, four user selectable output impedances are provided 25, 50, 75, 100 ohms.

Faulty cabls may be traced using the TX2003 warble tone feature , an oscilating tone is injected into the suspect power or transmission line and by using a commercially available tone tracing probe , the suspect line can be identified. Made in England.
 |
| BI Communications TX2003 Graphical TDR Cable Fault Locator Specifications: | | Ranges @ Vp=70%: |
 7, 15, 30, 60, 120, 250, 500, 1km, 2km, 3km, 6km
 |
| Feet: |
 23, 49, 98, 197, 394, 820, 1640, 3280, 6560, 9850, 19000
 |
| Range Selection: |
 Manaul range control
 |
| Backlit display: |
 128x64 pixel
 |
| Resolution: |
 Approximately 1% of range
 |
| Sensitivity: |
 Min. 3 pixel return at 4 km
 |
| Velocity Factor: |
 Adjustable from 1% to 99%
 |
| Output Pulse: |
 5v p-p into open circuit
 |
| Output Impedance: |
 Selectable 25, 50, 75 and 100 ohms
 |
| Output Pulse Width: |
 3ns min. 3MS, AUTORANGE
 |
| Scan Rate: |
 2 scans/second or scan held
 |
| Tone Generator: |
 Oscillating 810 - 1110Hz
 |
| Power: |
 6v 4 x AA cells
 |
| Battery Life: |
 60 hours continuous scanning
 |
| Power Down: |
 Selectable 1,2,3,5 mins or disabled
 |
| Voltage detection: |
 240 volts AC
 |
| Operating Temperature: |
 0 to 40 degree C
 |
| Storage Temperature: |
 -20 to 70 degree C
 |
| Dimensions (mm): |
 165 x 90 x 37
 |
| Weight: |
 350gms (12oz)
 |
| Safety: |
 IEC61010-1 EN60950
 |
| EMC: |
 BS/EN61326-1
 |
| CE Compliance: |
 To EU directives
 |
| Water/Dust Proof: |
 IP54
 |

Need Technical Advise? Please Call: 602-795-4033
Browse Similar Products |
|